Fulltone Secret Freq Manuel d'utilisateur télécharger pdf (Page 2)

Features

True Bypass On/Off switch (see #7) This is the best switch in the world…the Fulltone-made 3PDT footswitch.

The pedal is ON when the bright Red L.E.D. (see #10) is lit up...the pedal is bypassed when this light is OFF.

Distortion Knob: (see #2) Turn this Clockwise (CW) for more distortion, keep it below 10 0‘clock for cleaner sounds

and for overdriving your favorite amp. Clean-Boost sounds can be attained by lowering this knob almost full CCW,

and turning up the “Volume” knob.

Volume Knob: (see #1) This knob controls the amount of signal that exits the pedal. The ‘Freq. has about 30db of

available gain, more than most distortion or overdrive pedals offer, so don’t be surprised if you end up running the

Volume knob at only around 9 o’clock and are still getting a tremendous volume boost.

Freq knob: (see #3) This is the magic Midrange knob! Set Full counter-clockwise (CCW) for a pedal that has a transparent

sound and not a lot of Midrange. Now turn up the Freq knob and on comes the wah-wah-like midrange, the volume will

increase tremendously in the midrange frequencies only....very different from other pedal’s midrange controls in that

you can get infinite sustain with relatively low Distortion settings!

Highs Knob: (see #4)This is a “Hi-Cut” function only, meaning that this knob only affects upper Treble frequencies.

You’ll find that FULL CW position is very much neutral, depending on how much “Distortion” you are using.

You should turn it CCW to around 10 o’clock for smoother high-gain lead sounds or turn it CW for more clarity.

Input jack: (see #6) Plug the cable that is connected to your guitar into this jack. Note that the pedal will not power-on unless

you have a cable plugged in to this jack.

Output jack: (see #5) Plug the cable that goes to the amplifier into this jack.

Sample Settings (with Amp set Clean)

SRV-ish Rhythm tones Jimmy Page “Custard Pie” Brian May “We will Rock You”

Specifications

Input Impedance= 680K (good and high, like your guitar pickups)

Output Impedance= as low as 10K (nice and low to so as not to load down your guitar cables or cause interference with other pedals.

Max Voltage Gain= 60-80dBV (depending on settings, including the Freq knob)

Current draw= 6 ma. (milliamps) which means a battery should last months, and 50ma,100ma, 200ma, 500ma, adapters are fine.

DC Power Port: (see #8) You may run this pedal on the 9 volt battery (included) or on any voltage between 9 and 18 Volts DC as long as the adapter is (standard) 2.1mm x 5.5mm barrel plug with

“Negative to Center Pin” configuration. (as illustrated by the following diagram)

To access the battery remove all four Thumbscrews (see #9) from the sides of the pedal and pull the housing apart. Replace battery, put housing back together and re-tighten all four screws. Unplug

guitar cable from INPUT when not in use to prolong battery life but If you have an adapter plugged in to the DC outlet there is no need to unplug the guitar cable from the INPUT because our DC outlet

is True-Bypass and disconnects the battery supply line, thus keeping the battery fresh. The Fulltone FPS-1 is a great 9VDC regulated wall wart adapter. As far as pedalboard power supplies, we have

always recommended ours and the Voodoo Lab products....nothing’s changed, beware, there are some crappy power supplies being sold as “Pro product out there!

Warranty Fulltone products carry a Limited 5 year Warranty to the original owner with proof of purchase that the product was bought from an Authorized Fulltone Dealer. There is no need to register

your product, simply keep a copy of your original sales receipt. The Warranty covers failure due to manufacturing errors only and is void if any mod or repair is performed by anyone other than Fulltone

AND/OR if we deem that any operator-caused abuse or damage has occurred, for example; the use of an incorrect power supply, a dropped pedal, water damage, etc. Batteries are not warranty-

covered and Customer is always responsible for all shipping costs both to and from Fulltone. Do not attempt to call Fulltone, instead, all Repair issues are handled via email to troubleshoot the

possible problem and (after troubleshooting) for the scheduling of Warranty Repair. After we have deemed that a repair is necessary, we will email you an Acrobat PDF copy of our Return

Authorization Form (RA Form) and print it out, fill out all information, and include it with the device you are sending. Fulltone Musical Products Inc. is not responsible for and injuries and/or damages

related to the use of our products

Fulltone Musical Products Inc.

11018 Washington Blvd. Culver City, CA 90232

for more info and expanded information/videos go to www.fulltone.com and/or www.youtube.com/fulltoneeffects

Sales related questions email [email protected]

Repairs/Technical related questions email [email protected]

Features Diagram

9 9

1 2

Secret Freq 1
2

Commentaires sur ces manuels

Pas de commentaire

Fulltone Secret Freq Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires audio Fulltone Secret Freq